1. Connect the transparent charging cradle to the electrical plug.
  2. Plug the black and red cables inside the holes at the top of the transparent charging cradle (Make sure the red cable in plugged inside the hole in front of the little red mark).
  3. Clip the metal part from the black and red charging cables on the metal part of the contact points. (Make sure the red cable is on the contact point from the island with a red mark on it).
  4. Switch the collar ON. (If you hear a short melody while switching the collar ON, the collar is not charging => Please make sure that the black and red cables are installed as mentioned above).
  5. Once the battery from the receiver is fully charged, the blinking LED will remain still.

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed

Menu